I read about this type of bar on Barney Gaylord's mgguru site, I ordered it through NAPA, they only come with the urethane bushing's now. I had redone the front suspension this winter with new A bars, they had the reinforced holes for factory type sway bar. I wanted an easier install so decided not to do factory type. The Addco bracket had to be ground off on the corner next to the triangular A arm reinforcement. Too bad Addco doesn't make one to fit those reinforced holes.
I followed the simple instructions, drilled the A arm and front frame extension holes with 3/8" bit. I pre tested and preassembled with car on jack stands, positioned holes and tightened everything with weight on the suspension. For the pictures hold cursor over image to read headings.
