Simple Method of Storing 2" Velcro-backed Sanding Disks

	These are nothing more than scrap pieces of 2" x 6" Pine.   Holes are 2 1/8" diameter drilled with a Fortsner bit.  This could have been one piece of wood, but in my case, where I store them in the shop the smaller blocks work better.  I plan to eventually label the block with the grit number, but I usually write the grit # on the back before I use it, so this has sufficed to "identify" them.
	Holes are drilled such that the edge of the disk hangs out the side of the wood block.  This makes it easier to pick them out of the holder.